How to install
Fitted in a minute. No plumber needed.
Pick your shower below and follow the three steps. Changing your filter is just as easy.
Handheld Filter Shower
Fit your handheld
-
Step 1
Take off your old hand shower
Twist it off the hose by hand.
-
Step 2
Twist on your new one
Hand tight is enough. The filter is already inside.
-
Step 3
Run it for a few seconds
Then step in and enjoy your best shower yet.
Takes about a minute
Rain Filter Shower Head
Fit your rain head
-
Step 1
Take off your old shower head
Use the wrench from the box if it's stuck.
-
Step 2
Wrap the thread and twist on
A few turns of tape, then hand tight.
-
Step 3
Run it for a few seconds
Then stand under it.
Takes about two minutes
Every three months
Change your filter
-
Step 1
Twist open your shower
The handle or head unscrews by hand.
-
Step 2
Swap the filter
Old one out, new one in. It only fits one way.
-
Step 3
Close and rinse
Twist it shut and let it run for 30 seconds.
No tools needed and it takes less than a minute
Will it fit my shower?
The handheld fits the standard half inch hose thread used on almost every Australian hand shower. The rain head fits the standard half inch shower arm. Not sure? Send us a photo before you order and we'll confirm it.
Do I need a plumber or tools?
No. Everything you need is in the box. The rain head comes with a small wrench in case your old head is stuck.
It's dripping at the thread. What now?
Unscrew it, wrap two or three more turns of plumber's tape around the thread and tighten by hand again. Still dripping? Send us a message and we'll help.
I rent. Can I use it?
Yes. Nothing is drilled or glued. Keep your old shower head and put it back when you move out.
How often do I change the filter?
About every three months. Sooner in a busy household or a hard water area like Perth or Adelaide.
Which filter do I need?
The one that matches your shower. Choose Handheld Filter Shower or Rain Filter Shower Head on the filter page.